Concept Guide
To view only congured interfaces, use the show interfaces configured command in the EXEC Privilege mode.
To determine which physical interfaces are available, use the show running-config command in EXEC mode. This command displays
all physical interfaces available on the line cards.
Dell#show running
Current Configuration ...
!
interface TengigabitEthernet 9/6
no ip address
shutdown
!
interface TengigabitEthernet 9/7
no ip address
shutdown
!
interface TengigabitEthernet 9/8
no ip address
shutdown
!
interface TengigabitEthernet 9/9
no ip address
shutdown
Resetting an Interface to its Factory Default State
You can reset any congurations applied on an interface to its factory default state. To reset the conguration, perform the following steps:
1 View the congurations applied on an interface.
INTERFACE mode
show config
Dell(conf)# interface range tengigabitethernet 1/1 - 2
Dell(conf-if-range-te-1/1-2)# show config
!
interface TenGigabitEthernet 1/1
switchport
no shutdown
!
interface TenGigabitEthernet 1/2
no ip address
Interfaces 893
switchport
no shutdown
Dell(conf-if-range-te-1/1-2)#
2 Reset an interface to its factory default state.
CONFIGURATION mode
default interface interface-type slot/port[]
Dell(conf)#default interface tengigabitethernet 1/5
3 Verify the conguration.
INTERFACE mode
show config
Dell(conf-if-te-1/5)#show config
!
interface TenGigabitEthernet 1/5
no ip address
shutdown
448
Interfaces