Concept Guide
Assigning a Static IPv6 Route
To congure IPv6 static routes, use the ipv6 route command.
NOTE: After you congure a static IPv6 route (the ipv6 route command) and congure the forwarding router’s address
(specied in the ipv6 route command) on a neighbor’s interface, the IPv6 neighbor does not display in the show ipv6
route
command output.
• Set up IPv6 static routes.
CONFIGURATION mode
ipv6 route prefix type {slot/port} forwarding router tag
– prefix: IPv6 route prex
– type {slot/port}: interface type and slot/port
– forwarding router: forwarding router’s address
– tag: route tag
Enter the keyword interface then the type of interface and slot/port information:
– For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
– For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
– For a loopback interface, enter the keyword loopback then the loopback number.
– For a port-channel interface, enter the keywords port-channel then the port-channel number.
– For a VLAN interface, enter the keyword vlan then the VLAN ID.
– For a Null interface, enter the keyword null then the Null interface number.
Conguring Telnet with IPv6
The Telnet client and server on a switch supports IPv6 connections. You can establish a Telnet session directly to the router using an IPv6
Telnet client, or you can initiate an IPv6 Telnet connection from the router.
• Enter the IPv6 Address for the device.
EXEC mode or EXEC Privileged mode
telnet ipv6 address
– ipv6 address: x:x:x:x::x
– mask: prex length is from 0 to 128.
NOTE
: IPv6 addresses are normally written as eight groups of four hexadecimal digits, where each group is separated by a
colon (:). Omitting zeros is accepted as described in Addressing.
SNMP over IPv6
You can congure SNMP over IPv6 transport so that an IPv6 host can perform SNMP queries and receive SNMP notications from a
device running a Dell Networking OS that supports IPv6.
The SNMP-server commands for IPv6 have been extended to support IPv6. For more information regarding SNMP commands, refer to the
SNMP and SYSLOG chapters in the Dell Networking OS Command Line Reference Guide.
• snmp-server host
514
IPv6 Routing