Concept Guide
Create a Rule for a Redirect-list
The following example creates a redirect list by the name of “xyz.”
Dell(conf)#ip redirect-list ?
WORD Redirect-list name (max 16 chars)
Dell(conf)#ip redirect-list xyz
Use the following command in CONFIGURATION REDIRECT-LIST mode to set the rules for the redirect list. You can enter the
command multiple times and create a sequence of redirect rules. Use the seq nn redirect version of the command to organize your rules.
Table 69. Create a Rule for a Redirect-list
Command Syntax Command Mode Purpose
{seq sequence-number} redirect
{ip-address| tunnel tunnel-id}
[track obj-id] {protocol-type}
{source mask | any | host ip-
address} {destination mask |
any | host ip-address} [bit]
[operators]}
REDIRECT-LIST Congure a rule for the redirect list.
ip-address is the forwarding router’s address
tunnel — keyword to congure the tunnel
settings.
tunnel-id is used to redirect the trac.
Protocol-type — Enter one of the following
keywords as the protocol type
• icmp for Internet Control Message
Protocol
• ip for Any Internet Protocol
• tcp for Transmission Control Protocol
• udp for User Datagram Protocol
Optional
sequence-number (Optional) — Congures
a rule with an assigned sequence number for
the redirect list. Enter a number from 1 to
65535.
track — keyword to enable tracking.
track <obj-id> is used to track the object-id
for a host reachability track object. Enter a
number from 1 to 500. The track object
should correspond to the host tracking of
the forwarding router’s IP address
congured in this rule.
ip-protocol-number or protocol-type is the
type of protocol to be redirected
FORMAT: 0-255 for IP protocol number, or
enter protocol type (Optional):
• icmp — Internet Control Message
Protocol
• ip — Any Internet Protocol
• tcp — Transmission Control Protocol
744
Policy-based Routing (PBR)