Concept Guide

Dell(conf)#service-class wred ecn 0, 3-5, 7 backplane
Pre-Calculating Available QoS CAM Space
Pre-calculating available QoS CAM space allows you to measure the number of CAM entries a policy-map consumes.
This feature allows you to avoid applying a policy-map on an interface that requires more CAM entries than are available and receive a CAM
full error message (shown in the following example). The partial policy-map conguration might cause unintentional system behavior.
%EX2YD:12 %DIFFSERV-2-DSA_QOS_CAM_INSTALL_FAILED: Not enough space in L3
Cam(PolicyQos) for class 2 (Te 12/20) entries on portpipe 1 for linecard 12
%EX2YD:12 %DIFFSERV-2-
DSA_QOS_CAM_INSTALL_FAILED: Not enough space in L3 Cam(PolicyQos) for class 5 (Te 12/
22) entries on portpipe 1 for linecard 12
Use the test cam-usage command to verify that there are enough available CAM entries before applying a policy-map to an interface
so that you avoid exceeding the QoS CAM space and partial congurations. This command measures the size of the specied policy-map
and compares it to the available CAM space in a partition for a specied port-pipe.
Test the policy-map size against the CAM space for a specic port-pipe or all port-pipes using these commands:
• test cam-usage service-policy input policy-map linecard {0–2} number port-set number
• test cam-usage service-policy input policy-map linecard {0–2} all
The output of this command, shown in the following example, displays:
• The estimated number of CAM entries the policy-map will consume.
• Whether or not the policy-map can be applied.
• The number of interfaces in a port-pipe to which the policy-map can be applied.
Specically:
• Available CAM — the available number of CAM entries in the specied CAM partition for the specied line-card port pipe.
• Estimated CAM — the estimated number of CAM entries that the policy will consume when it is applied to an interface.
• Status — indicates whether the specied policy-map can be completely applied to an interface in the port-pipe.
– Allowed — indicates that the policy-map can be applied because the estimated number of CAM entries is less or equal to the
available number of CAM entries. The number of interfaces in the port-pipe to which the policy-map can be applied is given in
parentheses.
– Exception — indicates that the number of CAM entries required to write the policy-map to the CAM is greater than the number of
available CAM entries, and therefore the policy-map cannot be applied to an interface in the specied port-pipe.
NOTE
: The show cam-usage command provides much of the same information as the test cam-usage command, but
whether a policy-map can be successfully applied to an interface cannot be determined without rst measuring how many CAM
entries the policy-map would consume; the test cam-usage command is useful because it provides this measurement.
• Verify that there are enough available CAM entries.
test cam-usage
Example of the test cam-usage Command
Dell# test cam-usage service-policy input pmap_l2 linecard 0 port-set 0
Linecard | Port-pipe | CAM Partition | Available CAM | Estimated CAM | Status
===============================================================================
0 0 L2ACL 500 200 Allowed(2)
SNMP Support for Buer Statistics Tracking
SNMP support for buer statistics tracking (BST) counters is implemented in the F10-FPSTATS MIB. BST counters allow you to better
monitor system resources and allocate buer memory.
BST counters include the Max Use Count statistic, which provides the maximum counter value over a period of time.
870
Quality of Service (QoS)