Concept Guide

3 Specify the interfaces which send SNMP traps.
CONFIGURATION mode
snmp-server trap-source
Example of RFC-Dened SNMP Traps and Related Enable Commands
The following example lists the RFC-dened SNMP traps and the command used to enable each. The coldStart and warmStart traps are
enabled using a single command.
snmp authentication SNMP_AUTH_FAIL:SNMP Authentication failed.Request with invalid community
string.
snmp coldstart SNMP_COLD_START: Agent Initialized - SNMP COLD_START.
SNMP_WARM_START:Agent Initialized - SNMP WARM_START.
snmp linkdown PORT_LINKDN:changed interface state to down:%d
snmp linkup PORT_LINKUP:changed interface state to up:%d
Enabling a Subset of SNMP Traps
You can enable a subset of Dell Networking enterprise-specic SNMP traps using one of the following listed command options.
To enable a subset of Dell Networking enterprise-specic SNMP traps, use the following command.
Enable a subset of SNMP traps.
snmp-server enable traps
NOTE: The envmon option enables all environment traps including those traps that are enabled with the envmon
supply, envmon temperature, and envmon fan options.
The following traps are available.
bgp Enable BGP state change traps
config Enable configuration traps
ecfm Enable ECFM state change traps
ecmp Enable ecmp traps
entity Enable entity change traps
envmon Enable SNMP environmental monitor traps
ets Enable ets traps
fips Enable FIP Snooping state change traps
hg-lbm Enable higig Link Bundle Monitoring traps
isis Enable ISIS adjacency change traps
lacp Enable LACP state change traps
pfc Enable pfc traps
snmp Enable SNMP traps
stp Enable STP traps
vlt Enable VLT traps
vrrp Enable VRRP state change traps
xstp Enable 802.1s, 802.1w, and PVST+ state change traps
Example of Dell Networking Enterprise-specic SNMP Traps
coldStart and warmStart traps are enabled using a single command
snmp authentication SNMP_AUTH_FAIL:SNMP Authentication failed.Request with
invalid community string.
snmp coldstart SNMP_COLD_START: Agent Initialized - SNMP COLD_START.
SNMP_WARM_START:Agent Initialized - SNMP WARM_START.
snmp linkdown PORT_LINKDN:changed interface state to down:%d
snmp linkup PORT_LINKUP:changed interface state to up:%
envmon
LINECARDUP: %sLine card %d is up
CARD_MISMATCH: Mismatch: line card %d is type %s - type %s required.
TASK SUSPENDED: SUSPENDED - svce:%d - inst:%d - task:%s
SYSTEM-P:CP %CHMGR-2-CARD_PARITY_ERR
ABNORMAL_TASK_TERMINATION: CRASH - task:%s %s
CPU_THRESHOLD: Cpu %s usage above threshold. Cpu5SecUsage (%d)
Simple Network Management Protocol (SNMP)
989