Administrator Guide

Reconguring the Default VLT Settings (Optional)
To recongure the default VLT settings, use the following commands.
1 Enter VLT-domain conguration mode for a specied VLT domain.
CONFIGURATION mode
vlt domain domain-id
The range of domain IDs is from 1 to 1000.
2 (Optional) When you create a VLT domain on a switch, the system automatically creates a VLT-system MAC address used for internal
system operations.
VLT DOMAIN CONFIGURATION mode
system-mac mac-address mac-address
To explicitly congure the default MAC address for the domain by entering a new MAC address, use the system-mac command. The
format is aaaa.bbbb.cccc.
Also, recongure the same MAC address on the VLT peer switch.
Use this command to minimize the time required for the VLT system to synchronize the default MAC address of the VLT domain on
both peer switches when one peer switch reboots.
3 (Optional) When you create a VLT domain on a switch, the system automatically assigns a unique unit ID (0 or 1) to each peer switch.
VLT DOMAIN CONFIGURATION mode
unit-id {0 | 1}
To explicitly congure the default values on each peer switch, use the unit-id command.
Congure a dierent unit ID (0 or 1) on each peer switch.
Unit IDs are used for internal system operations.
Use this command to minimize the time required for the VLT system to determine the unit ID assigned to each peer switch when one
peer switch reboots.
Connecting a VLT Domain to an Attached Access Device
(Switch or Server)
To connect a VLT domain to an attached access device, use the following commands.
On a VLT peer switch: To connect to an attached device, congure the same port channel ID number on each peer switch in the VLT
domain.
1 Congure the same port channel to be used to connect to an attached device and enter interface conguration mode.
CONFIGURATION mode
interface port-channel id-number
2 Remove an IP address from the interface.
INTERFACE PORT-CHANNEL mode
no ip address
1062
Virtual Link Trunking (VLT)