Administrator Guide
Sample Congurations
Before you set up VRRP, review the following sample congurations.
VRRP for an IPv4 Conguration
The following conguration shows how to enable IPv4 VRRP. This example does not contain comprehensive directions and is intended to
provide guidance for only a typical VRRP conguration. You can copy and paste from the example to your CLI. To support your own IP
addresses, interfaces, names, and so on, be sure that you make the necessary changes. The VRRP topology was created using the CLI
conguration shown in the following example.
Figure 156. VRRP for IPv4 Topology
Example of Conguring VRRP for IPv4 Router 2
R2(conf)#int te 2/31
R2(conf-if-te-2/31)#ip address 10.1.1.1/24
Virtual Router Redundancy Protocol (VRRP)
1101