Administrator Guide

NOTE: To end output from the system, such as the output from the show interfaces command, enter CTRL+C. The
system returns you to the command prompt.
NOTE: The CLI output may be incorrectly displayed as 0 (zero) for the Rx/Tx power values. To obtain the correct power
information, perform a simple network management protocol (SNMP) query.
Examples of Using the Show Commands
The following example shows the conguration and status information for one interface.
Dell#show interface tengigabitethernet 1/12
TenGigabitEthernet 1/12 is up, line protocol is up
Hardware is DellEth, address is 34:17:eb:01:dc:27
Current address is 34:17:eb:01:dc:27
Pluggable media present, SFP+ type is 10GBASE-ACU15M
Medium is MultiRate
Interface index is 2098692
Internet address is not set
Mode of IPv4 Address Assignment : NONE
DHCP Client-ID :3417eb01dc27
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 10000 Mbit
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 07:40:05
Queueing strategy: fifo
Input Statistics:
8748 packets, 1539208 bytes
0 64-byte pkts, 0 over 64-byte pkts, 8748 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
8748 Multicasts, 0 Broadcasts, 0 Unicasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
904 packets, 61472 bytes, 0 underruns
0 64-byte pkts, 904 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
904 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 10:45:43
The following example shows information about port extender interfaces. For more information about the show port extender commands,
see Displaying Information About PE Stacks.
Dell#show interfaces peGigE ?
PE-ID/UNIT PE-ID/Unit number
PE-ID/UNIT/PORT PE Gigabit Ethernet interface
Dell#show interface peGigE 255/1/1
peGigE 255/1/1 is up, line protocol is up
Hardware is DellEth, address is 6c:c0:00:43:09:91
Current address is 6c:c0:00:43:09:91
Pluggable media not present
Interface index is 804323335
Internet address is not set
Mode of IPv4 Address Assignment : NONE
DHCP Client-ID :6cc000430991
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed auto, Mode auto
Auto-mdix enabled, ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 1d18h43m
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
Interfaces
431