Administrator Guide

no ip address
shutdown
!
interface TengigabitEthernet 9/7
no ip address
shutdown
!
interface TengigabitEthernet 9/8
no ip address
shutdown
!
interface TengigabitEthernet 9/9
no ip address
shutdown
Resetting an Interface to its Factory Default State
You can reset any congurations applied on an interface to its factory default state. To reset the conguration, perform the following steps:
1 View the congurations applied on an interface.
INTERFACE mode
show config
Dell(conf)# interface range tengigabitethernet 1/1 - 2
Dell(conf-if-range-te-1/1-2)# show config
!
interface TenGigabitEthernet 1/1
switchport
no shutdown
!
interface TenGigabitEthernet 1/2
no ip address
Interfaces 893
switchport
no shutdown
Dell(conf-if-range-te-1/1-2)#
2 Reset an interface to its factory default state.
CONFIGURATION mode
default interface interface-type slot/port[]
Dell(conf)#default interface tengigabitethernet 1/5
3 Verify the conguration.
INTERFACE mode
show config
Dell(conf-if-te-1/5)#show config
!
interface TenGigabitEthernet 1/5
no ip address
shutdown
All the applied congurations are removed and the interface is set to the factory default state.
Enabling a Physical Interface
After determining the type of physical interfaces available, to enable and congure the interfaces, enter INTERFACE mode by using the
interface interface {slot/port | pe-id/stack-unit/port} command.
1 Enter the keyword interface then the type of interface and slot/port information.
436
Interfaces