Administrator Guide
Bulk Conguration
Bulk conguration allows you to determine if interfaces are present for physical interfaces or congured for logical interfaces.
Interface Range
An interface range is a set of interfaces to which other commands may be applied and may be created if there is at least one valid interface
within the range.
Bulk conguration excludes from conguration any non-existing interfaces from an interface range. A default VLAN may be congured only
if the interface range being congured consists of only VLAN ports.
The interface range command allows you to create an interface range allowing other commands to be applied to that range of
interfaces.
The interface range prompt oers the interface (with slot and port information) for valid interfaces. The maximum size of an interface
range prompt is 32. If the prompt size exceeds this maximum, it displays (...) at the end of the output.
NOTE: Non-existing interfaces are excluded from the interface range prompt. In the following example, 10 Gigabit 3/0 and VLAN
1000 do not exist.
NOTE: When creating an interface range, interfaces appear in the order they were entered and are not sorted.
The show range command is available under Interface Range mode. This command allows you to display all interfaces that have been
validated under the interface range context.
The show configuration command is also available under Interface Range mode. This command allows you to display the running
conguration only for interfaces that are part of interface range.
Bulk Conguration Examples
Use the interface range command for bulk conguration.
• Create a Single-Range
• Create a Multiple-Range
• Exclude Duplicate Entries
• Exclude a Smaller Port Range
• Overlap Port Ranges
• Commas
• Add Ranges
Create a Single-Range
The following is an example of a single range.
Dell(config)# interface range tengigabitethernet 0/1 - 23
Dell(config-if-range-te-0/1-23)# no shutdown
Dell(config-if-range-te-0/1-23)#
The following is an example of single range on PE ports.
Dell(config)#interface range peGigE 1/0/4-47
Dell(conf-if-range-pegi-1/0/4-47)# no shut
Dell(conf-if-range-pegi-1/0/4-47)#
Interfaces
453