Administrator Guide

IPv6 Reachability and IPv6 Interface Address. Also, a new IPv6 protocol identier has also been included in the supported TLVs. The new
TLVs use the extended metrics and up/down bit semantics.
Multi-topology IS-IS adds TLVs:
• MT TLV — contains one or more Multi-Topology IDs in which the router participates. This TLV is included in IIH and the rst fragment
of an LSP.
• MT Intermediate Systems TLV — appears for every topology a node supports. An MT ID is added to the extended IS reachability TLV
type 22.
• MT Reachable IPv4 Prexes TLV — appears for each IPv4 an IS announces for a given MT ID. Its structure is aligned with the
extended IS Reachability TLV Type 236 and it adds an MT ID.
• MT Reachable IPv6 Prexes TLV — appears for each IPv6 an IS announces for a given MT ID. Its structure is aligned with the
extended IS Reachability TLV Type 236 and add an MT ID.
By default, the system supports dynamic host name exchange to assist with troubleshooting and conguration. By assigning a name to an
IS-IS NET address, you can track IS-IS information on that address easier. The system does not support ISO CLNS routing; however, the
ISO NET format is supported for addressing.
To support IPv6, the Dell Networking implementation of IS-IS performs the following tasks:
• Advertises IPv6 information in the PDUs.
• Processes IPv6 information received in the PDUs.
• Computes routes to IPv6 destinations.
• Downloads IPv6 routes to the RTM for installing in the FIB.
• Accepts external IPv6 information and advertises this information in the PDUs.
The following table lists the default IS-IS values.
Table 40. IS-IS Default Values
IS-IS Parameter Default Value
Complete sequence number PDU (CSNP) interval 10 seconds
IS-to-IS hello PDU interval 10 seconds
IS-IS interface metric 10
Metric style Narrow
Designated Router priority 64
Circuit Type Level 1 and Level 2
IS Type Level 1 and Level 2
Equal Cost Multi Paths 16
Conguration Information
To use IS-IS, you must congure and enable IS-IS in two or three modes: CONFIGURATION ROUTER ISIS, CONFIGURATION INTERFACE,
and ( when conguring for IPv6) ADDRESS-FAMILY mode. Commands in ROUTER ISIS mode congure IS-IS globally, while commands
executed in INTERFACE mode enable and congure IS-IS features on that interface only. Commands in the ADDRESS-FAMILY mode are
specic to IPv6.
NOTE
: When using the IS-IS routing protocol to exchange IPv6 routing information and to determine destination reachability, you
can route IPv6 along with IPv4 while using a single intra-domain routing protocol. The conguration commands allow you to
enable and disable IPv6 routing and to congure or remove IPv6 prexes on links.
Except where identied, the commands described in this chapter apply to both IPv4 and IPv6 versions of IS-IS.
512
Intermediate System to Intermediate System