Administrator Guide

Congure the following parameters for the virtual terminal lines:

• number: the range is from zero (0) to 8.

• end-number: the range is from 1 to 8.

You can congure multiple virtual terminals at one time by entering a number and an end-number.

2 Congure a level and set the maximum number of messages to print.

LINE mode

logging synchronous [level severity-level | all] [limit]

Congure the following optional parameters:

• level severity-level: the range is from 0 to 7. The default is 2. Use the all keyword to include all messages.

• limit: the range is from 20 to 300. The default is 20.

To view the logging synchronous conguration, use the show config command in LINE mode.

Enabling Timestamp on Syslog Messages

By default, syslog messages do not include a time/date stamp stating when the error or message was created.

To enable timestamp, use the following command.

• Add timestamp to syslog messages.

CONFIGURATION mode

service timestamps [log | debug] [datetime [localtime] [msec] [show-timezone] | uptime]

Specify the following optional parameters:

• You can add the keyword localtime to include the localtime, msec, and show-timezone. If you do not add the keyword

localtime, the time is UTC.

• uptime: To view time since last boot.

If you do not specify a parameter, the system congures uptime.

To view the conguration, use the show running-config logging command in EXEC privilege mode.

To disable time stamping on syslog messages, use the no service timestamps [log | debug] command.

File Transfer Services

You can congure the system to transfer les over the network using the le transfer protocol (FTP).

You can use the FTP application to copy system image les over an interface on to the system. However, FTP is not supported on virtual

local area network (VLAN) interfaces.

For more information about FTP, refer to RFC 959, File Transfer Protocol.

NOTE

: To transmit large les, Dell Networking recommends conguring the switch as an FTP

server.

Conguration Task List for File Transfer Services

The conguration tasks for le transfer services are:

• Enable FTP Server (mandatory)

Switch Management