Administrator Guide

Display a specic DSCP color map.
Dell# show qos dscp-color-map mapTWO
Dscp-color-map mapTWO
yellow 16,55
Displaying a DSCP Color Policy Conguration
To display the DSCP color policy conguration for one or all interfaces, use the show qos dscp-color-policy {summary
[interface] | detail {interface}} command in EXEC mode.
summary: Displays summary information about a color policy on one or more interfaces.
detail: Displays detailed color policy information on an interface
interface : Enter the name of the interface that has the color policy congured.
Examples for Displaying a DSCP Color Policy
Display summary information about a color policy for one or more interfaces.
Dell# show qos dscp-color-policy summary
Interface dscp-color-map
TE 0/10 mapONE
TE0/11 mapTWO
Display summary information about a color policy for a specic interface.
Dell# show qos dscp-color-policy summary te 0/10
Interface dscp-color-map
TE 0/10 mapONE
Display detailed information about a color policy for a specic interface
Dell# show qos dscp-color-policy detail te 0/10
Interface TenGigabitEthernet 0/10
Dscp-color-map mapONE
yellow 4,7
red 20,30
Enabling QoS Rate Adjustment
By default, while rate limiting, policing, and shaping, the system does not include the Preamble, SFD, or the IFG elds. These elds are
overhead; only the elds from MAC destination address to the CRC are used for forwarding and are included in these rate metering
calculations.
The Ethernet packet format consists of:
• Preamble: 7 bytes Preamble
• Start frame delimiter (SFD): 1 byte
• Destination MAC address: 6 bytes
• Source MAC address: 6 bytes
• Ethernet Type/Length: 2 bytes
• Payload: (variable)
• Cyclic redundancy check (CRC): 4 bytes
• Inter-frame gap (IFG): (variable)
You can optionally include overhead elds in rate metering calculations by enabling QoS rate adjustment.
QoS rate adjustment is disabled by default, and no qos-rate-adjust is listed in the running-conguration
830
Quality of Service (QoS)