Administrator Guide
• Set the delay time for VRRP initialization on an individual interface.
INTERFACE mode
vrrp delay minimum seconds
This time is the gap between an interface coming up and being operational, and VRRP enabling.
The seconds range is from 0 to 900.
The default is 0.
• Set the delay time for VRRP initialization on all the interfaces in the system congured for VRRP.
INTERFACE mode
vrrp delay reload seconds
This time is the gap between system boot up completion and VRRP enabling.
The seconds range is from 0 to 900.
The default is 0.
Track an Interface or Object
You can set Dell Networking OS to monitor the state of any interface according to the virtual group.
Each VRRP group can track up to 12 interfaces and up to 20 additional objects, which may aect the priority of the VRRP group. If the
tracked interface goes down, the VRRP group’s priority decreases by a default value of 10 (also known as cost). If the tracked interface’s
state goes up, the VRRP group’s priority increases by 10.
The lowered priority of the VRRP group may trigger an election. As the Master/Backup VRRP routers are selected based on the VRRP
group’s priority, tracking features ensure that the best VRRP router is the Master for that group. The sum of all the costs of all the tracked
interfaces must be less than the congured priority on the VRRP group. If the VRRP group is congured as Owner router (priority 255),
tracking for that group is disabled, irrespective of the state of the tracked interfaces. The priority of the owner group always remains at
255.
For a virtual group, you can track the line-protocol state or the routing status of any of the following interfaces with the interface
interface parameter:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port.
• For a 40-Gigabit Ethernet: enter fortyGigE slot/port.
• For a port extender 1-Gigabit Ethernet interface, enter the keyword peGigE then the pe-id/stack-unit /port-id information.
• For a port extender 10-Gigabit Ethernet interface, enter the keyword peTenGigE then the pe-id/stack-unit /port-id information.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
For a virtual group, you can also track the status of a congured object (the track object-id command) by entering its object
number.
NOTE
: You can congure a tracked object for a VRRP group (using the track object-id command in INTERFACE-VRID
mode) before you actually create the tracked object (using a track object-id command in CONFIGURATION mode).
However, no changes in the VRRP group’s priority occur until the tracked object is dened and determined to be down.
In addition, if you congure a VRRP group on an interface that belongs to a VRF instance and later congure object tracking on an
interface for the VRRP group, the tracked interface must belong to the VRF instance.
Virtual Router Redundancy Protocol (VRRP)
1143