Administrator Guide

• Carrying MPLS labels in BGP is not supported. The f10BgpM2NlriOpaqueType and f10BgpM2NlriOpaquePointer elds are set to zero.
• 4-byte ASN is supported. The f10BgpM2AsPath4byteEntry table contains 4-byte ASN-related parameters based on the conguration.
Traps (notications) specied in the BGP4 MIB draft <draft-ietf-idr-bgp4–mibv2–05.txt> are not supported. Such traps
(bgpM2Established and bgpM2BackwardTransition) are supported as part of RFC 1657.
Conguration Information
The software supports BGPv4 as well as the following:
• deterministic multi-exit discriminator (MED) (default)
• a path with a missing MED is treated as worst path and assigned an MED value of (0x)
• the community format follows RFC 1998
• delayed conguration (the software at system boot reads the entire conguration le prior to sending messages to start BGP peer
sessions)
The following are not yet supported:
• auto-summarization (the default is no auto-summary)
• synchronization (the default is no synchronization)
BGP Conguration
To enable the BGP process and begin exchanging information, assign an AS number and use commands in ROUTER BGP mode to
congure a BGP neighbor.
By default, BGP is disabled.
By default, the system compares the MED attribute on dierent paths from within the same AS (the bgp always-compare-med
command is not enabled).
NOTE
: All newly congured neighbors and peer groups are disabled. To enable a neighbor or peer group, enter the neighbor
{ip-address | peer-group-name} no shutdown command.
The following table displays the default values for BGP in the Dell Networking OS.
Table 9. BGP Default Values
Item Default
BGP Neighbor Adjacency changes All BGP neighbor changes are logged.
Fast External Fallover feature Disabled
Graceful Restart feature Disabled
Local preference 100
MED 0
Route Flap Damping Parameters
half-life = 15 minutes
reuse = 750
suppress = 2000
max-suppress-time = 60 minutes
Distance
external distance = 20
194 Border Gateway Protocol IPv4 (BGPv4)