Administrator Guide

Setting CAM Threshold and Silence Period
To congure the CAM threshold and silence period, use the following commands.
• Assign the CAM threshold percentage
CONFIGURATION mode
cam-threshold threshold {default | threshold-percent}
The range of threshold value is from 1 to 100. The default threshold value is 90 percent.
• Assign the silence period for syslog warning.
CONFIGURATION mode
cam-threshold threshold {default | threshold-percent} silence-period {default | silence-
period-value}
The range of silence period is from 0 to 65535. The default is 0 seconds.
NOTE:
If you delete a FP in a CAM region that is assigned with threshold, a syslog warning appears even during the silence period.
The system triggers syslog during the following events:
• Re-congure the CAM threshold
• Add or delete an ACL rule
Example of Syslog message on CAM usage
Following table shows few possible scenarios during which the syslog message appear on re-conguring the CAM usage threshold value.
Consider if the last CAM threshold was set to 90 percent and now you re-congure the CAM threshold to 80. And, if the current CAM
usage is 85 percent, then the system displays the syslog message saying that the CAM usage is above the congured CAM threshold
value.
Table 10. Possible Scenarios of Syslog Warning
Old CAM Threshold New CAM Threshold Current CAM
Usage
Syslog
90 80 85
DellEMC(conf)#Nov 5
19:55:12 %S6000:0 %ACL_AGENT-4-
ACL_AGENT_CAM_USAGE_OVER_THE_THRESHOLD: The
Ipv4Acl cam region on stack-unit 0 Portpipe 0
Pipeline 0 is more than 80% Full.
90 95 91
DellEMC(conf)#Nov 5
19:55:12 %S6000:0 %ACL_AGENT-4-
ACL_AGENT_CAM_USAGE_BELOW_THE_THRESHOLD: The
cam-usage of Ipv4Acl cam region on stack-unit 0
Portpipe 0 Pipeline 0 is below 95%.
98 100 100 No syslog
95 80 10 No syslog
Content Addressable Memory (CAM) 243