Administrator Guide

– PFC enabled or disabled
– No bandwidth limit or no ETS processing
• ETS uses the DCB MIB IEEE 802.1azd2.5.
Data Center Bridging Exchange Protocol (DCBx)
By default, the data center bridging exchange (DCBx) protocol is disabled; ETS is also disabled.
DCBx allows a switch to automatically discover DCB-enabled peers and exchange conguration information. PFC and ETS use DCBx to
exchange and negotiate parameters with peer devices. DCBx capabilities include:
• Discovery of DCB capabilities on peer-device connections.
• Determination of possible mismatch in DCB conguration on a peer link.
• Conguration of a peer device over a DCB link.
DCBx requires the link layer discovery protocol (LLDP) to provide the path to exchange DCB parameters with peer devices. Exchanged
parameters are sent in organizationally specic TLVs in LLDP data units. For more information, see Link Layer Discovery Protocol (LLDP).
The following LLDP TLVs are supported for DCB parameter exchange:
PFC parameters PFC Conguration TLV and Application Priority Conguration TLV.
ETS parameters ETS Conguration TLV and ETS Recommendation TLV.
Data Center Bridging in a Trac Flow
The following gure shows how DCB handles a trac ow on an interface.
Figure 30. DCB PFC and ETS Trac Handling
Data Center Bridging (DCB)
267