Administrator Guide

on the psh bit
range Match
only packets in the range of
port numbers
rst Match
on the rst bit
syn Match
on the syn bit
urg Match
on the urg bit
cr
Dell(conf-redirect-
list)#redirect 1.1.1.1 udp any
any ?
eq Match
only packets on a given port
number
gt Match
only packets with a greater
port number
lt Match
only packets with a lower port
number
neq Match
only packets not on a given
port number
range Match
only packets in the range of
port numbers
Delete a rule with the
no redirect command.
The redirect rule supports Non-contiguous bitmasks for PBR in the Destination router IP
address
Creating a Rule Example:
The below step shows a step-by-step example of how to create a rule for a redirect list by conguring:
• IP address of the next-hop router in the forwarding route
• IP protocol number
• Source address with mask information
• Destination address with mask information
Dell(conf-redirect-list)#redirect ?
A.B.C.D Forwarding router's address
Dell(conf-redirect-list)#redirect 3.3.3.3 ?
<0-255> An IP protocol number
icmp Internet Control Message Protocol
ip Any Internet Protocol
tcp Transmission Control Protocol
udp User Datagram Protocol
Dell(conf-redirect-list)#redirect 3.3.3.3 ip ?
A.B.C.D Source address
any Any source host
host A single source host
Dell(conf-redirect-list)#redirect 3.3.3.3 ip 222.1.1.1 ?
Mask A.B.C.D or /nn Mask in dotted decimal or in slash format
Dell(conf-redirect-list)#redirect 3.3.3.3 ip 222.1.1.1 /32 ?
A.B.C.D Destination address
any Any destination host
host A single destination host
744
Policy-based Routing (PBR)