Administrator Guide

a Remove the front and rear parts of the left 4-post rail from the Dell ReadyRails kit and slide the parts together. (The front and
rear parts of a rail may arrive pre-assembled.)
b Install a cage nut (item 2 in Figure 11) in the left front post at the desired height of the thumb screw on the left front rail.
c Install a cage nut in the left rear post at the same height as the cage nut in the left front post.
d Position the left rail so that the rail end labeled FRONT faces inward.
e Start with the rear left rail (item 3 in Figure 11); align the thumb screw with the cage nut and holes on the left rear post. Gently
press the rear rail end into the rack post and tighten the thumb screw in the cage nut to secure the rail to the post.
f Align the thumb screw on the front left rail with the cage nut (items 1 and 2 in Figure 11) inserted in the front post. Press the
front end of the rail forward and tighten the thumb screw so that it locks into the cage nut.
g Repeat Steps (a) through (f) to install the right rail.
h To remove or reposition a rail, loosen the thumb screw on each end and unseat the rail from the rack.
Figure 11. Installing Tool-less Rails in a Non-Threaded-Hole Rack
Installing the Hardware
19