Administrator Guide

• Member VLANs across multiple rings are not supported in Master nodes.
To create the control VLAN for this FRRP group, use the following commands on the switch that is to act as the Master node.
1. Create a VLAN with this ID number.
CONFIGURATION mode.
interface vlan vlan-id
VLAN ID: from 1 to 4094.
2. Tag the specified interface or range of interfaces to this VLAN.
CONFIG-INT-VLAN mode.
tagged interface slot/ port {range}
Interface:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
Slot/Port, Range: Slot and Port ID for the interface. Range is entered Slot/Port-Port.
3. Assign the Primary and Secondary ports and the control VLAN for the ports on the ring.
CONFIG-FRRP mode.
interface primary int slot/port secondary int slot/port control-vlan vlan id
Interface:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
Slot/Port, Range: Slot and Port ID for the interface. Range is entered Slot/Port-Port.
VLAN ID: The VLAN identification of the control VLAN.
4. Configure the Master node.
CONFIG-FRRP mode.
mode master
5. Identify the Member VLANs for this FRRP group.
CONFIG-FRRP mode.
member-vlan vlan-id {range}
VLAN-ID, Range: VLAN IDs for the ring’s member VLANS.
6. Enable FRRP.
CONFIG-FRRP mode.
no disable
Configuring and Adding the Member VLANs
Control and member VLANS are configured normally for Layer 2. Their status as Control or Member is determined at the FRRP group
commands.
For more information about configuring VLANS in Layer 2 mode, refer to the Layer 2 chapter.
Be sure to follow these guidelines:
• All VLANS must be in Layer 2 mode.
• Tag control VLAN ports. Member VLAN ports, except the Primary/Secondary interface, can be tagged or untagged.
• The control VLAN must be the same for all nodes on the ring.
To create the Members VLANs for this FRRP group, use the following commands on all of the Transit switches in the ring.
1. Create a VLAN with this ID number.
CONFIGURATION mode.
interface vlan vlan-id
VLAN ID: the range is from 1 to 4094.
2. Tag the specified interface or range of interfaces to this VLAN.
CONFIG-INT-VLAN mode.
tagged interface slot/port {range}
364
Force10 Resilient Ring Protocol (FRRP)