Administrator Guide

On the C9010, port interface numbers are written above the ports. The following examples show port numbering on C9010 line cards
(40GbE QSFP+, 1/10GbE SFP+, and 1/10GbE RJ-45).
Figure 50. 40GbE QSFP+ Port Numbering
On the 6-Port 40GbE QSFP+ line card, ports are numbered from 0 to 5 and operate by default in 40GbE mode. If you use a breakout
cable, each port can operate in 10G mode. 40GbE ports are numbered in multiples of four, starting with zero; for example, 0, 4, 8, 12, and
so on. When you install a breakout cable, the resulting four 10GbE ports are numbered with the remaining numbers. For example, 40GbE
port 0 contains 10GbE ports 0, 1, 2, and 3; 40GbE port 4 contains 10GbE ports 4, 5, 6, and 7.
NOTE: To locate a 4x10G port, enter the system location-led interface {fortyGigE |
tengigabitethernet} slot/port on command. The 4x10G port LED turns solid blue.
Figure 51. 1/10GbE SFP+ Port Numbering
On the 1/10GbE SFP+ line card, ports are numbered from 0 to 23 and operate in 1/10G mode.
Figure 52. 1/10GbE RJ-45 Port Numbering
On the 1/10GbE RJ-45 line card, ports are numbered from 0 to 23 and operate in 1/10G mode.
Interfaces
391