Administrator Guide

Implementation Information
• The Dell Networking OS implementation of PVST+ is based on IEEE Standard 802.1w.
• The Dell Networking OS implementation of PVST+ uses IEEE 802.1s costs as the default costs (as shown in the following table). Other
implementations use IEEE 802.1w costs as the default costs. If you are using Dell Networking systems in a multivendor network, verify
that the costs are values you intended.
Configure Per-VLAN Spanning Tree Plus
Configuring PVST+ is a four-step process.
1. Configure interfaces for Layer 2.
2. Place the interfaces in VLANs.
3. Enable PVST+.
4. Optionally, for load balancing, select a nondefault bridge-priority for a VLAN.
Related Configuration Tasks
• Modifying Global PVST+ Parameters
• Modifying Interface PVST+ Parameters
• Configuring an EdgePort
• Flush MAC Addresses after a Topology Change
• Prevent Network Disruptions with BPDU Guard
• Enabling SNMP Traps for Root Elections and Topology Changes
• PVST+ in Multi-Vendor Networks
• Enabling PVST+ Extended System ID
• PVST+ Sample Configurations
Enabling PVST+
When you enable PVST+, the system instantiates STP on each active VLAN.
1. Enter PVST context.
PROTOCOL PVST mode
protocol spanning-tree pvst
2. Enable PVST+.
PROTOCOL PVST mode
no disable
Disabling PVST+
To disable PVST+ globally or on an interface, use the following commands.
• Disable PVST+ globally.
PROTOCOL PVST mode
disable
• Disable PVST+ on an interface, or remove a PVST+ parameter configuration.
INTERFACE mode
no spanning-tree pvst
To display your PVST+ configuration, use the show config command from PROTOCOL PVST mode.
Dell_E600(conf-pvst)#show config verbose
!
protocol spanning-tree pvst
no disable
vlan 100 bridge-priority 4096
638
Per-VLAN Spanning Tree Plus (PVST+)