Administrator Guide

Cascade LAG: Po 258, Local Status: Up, Remote Status: Up
PE Configuration: Local Status: Present, Remote Status: Present
------------------------------------------------------------------------
Stack-id Status Reason Type UnitMac No. of Ports
------------------------------------------------------------------------
1 online - C1048P f8:b1:56:6e:20:07 52
Dell#
On the VLT peer:
Dell#show pe 1
Codes: A - Active, I - Inactive
SVC - Software Version Compatible
Reason: CTM - Card Type Mismatch, CAM - CAM ACL Mismatch
SVM - Software Version Mismatch, UE - Unknown Error
Offline Reason: UNP - Unit Not Present, PVE - Port Validation Error
ICE - IPC CP Error, IRE - IPC RP Error
ISE - IPC Setup Error, CVE - Card Validation Error
PE-ID assigned: 1
Status: online
System Mac: f8:b1:56:6e:20:07
PE Up Time: 00:17:15
PE Discovery Status: Provisioned PE
User Configured Cascade Ports: Te 1/4(A)
Cascade LAG: Po 258, Local Status: Up, Remote Status: Up
PE Configuration: Local Status: Present, Remote Status: Present
------------------------------------------------------------------------
Stack-id Status Reason Type UnitMac No. of Ports
------------------------------------------------------------------------
1 online - C1048P f8:b1:56:6e:20:07 52
Standalone System
You can connect a standalone system to a system that already has a PE to make it dual homed. In the following illustration, PE 1 is
connected to System A and System B is a standalone.
Figure 111. Standalone System and System with PE — Before setting up Dual Homing
To convert the above system into a dual homing setup, perform the following:
1. Repeat the steps 2 to 7 from Systems with Port Extender.
2. Change the uplink port connections of the PE, so that the uplink ports are connected to each of the VLT peers. In the above example,
the link connected to Te 0/1 in System A is disconnected and connected to Te 1/4 in System B.
Port Extenders (PEs)
681