Administrator Guide

3. Configure the PE interface through batch mode of System A.

PE CONFIGURATION (BATCH mode)

Dell#cascade interface TenGigabitEthernet 0/0

4. Configure the cascade interface of the System B through the batch mode of System A and commit the configuration.

PE CONFIGURATION (BATCH mode)

cascade interface interface slot/port peer

Dell# cascade interface TenGigabitEthernet 1/4 peer

Once the cascade interfaces are configured, the PE starts functioning in a dual homing setup as shown in the following diagram:

Figure 114. Systems without Port Extender — After setting up Dual Homing

You can configure PE 1 from both System A and System B.

Upgrading to OS 9.10(0.0)

To upgrade the Dell Networking OS 9.9(0.0) to OS 9.10(0.0):

• Upgrade the bootflash of the devices to 3.3.1.18 in OS 9.10.0.0.

• Upgrade the system-image in the Controlling Bridge (CB). Select the flash partition path to boot from, then Save and Reload.

The following example shows a CB and a PE running OS 9.9(0.0):

Dell#show version

Dell Real Time Operating System Software

Dell Operating System Version: 2.0

Dell Application Software Version: 9.9(0.0)

Build Time: Tue Sep 8 03:51:15 2015

Build Path: /sites/eqx/work/swbuild01_1/patch02/E9-9-0/SW/SRC

Dell Networking OS uptime is 10 minute(s)

System image file is "system://A"

System Type: C9010

Control Processor: Intel Rangeley with 2 Gbytes (2127536128 bytes) of memory, core(s) 4.

Route Processor: Intel Rangeley with 2 Gbytes (2127536128 bytes) of memory, core(s) 4.

16G bytes of boot flash memory.

2 Route Processor Module.

1 24-port TE/GE

2 4-port TE/GE

32 Ten GigabitEthernet/IEEE 802.3 interface(s)

Dell#

Port Extenders (PEs)

683