Users Guide

support your own IP addresses, interfaces, names, and so on, be sure that you make the necessary changes. The VRRP
topology was created using the CLI configuration shown in the following example.
Figure 149. VRRP for IPv4 Topology
Example of Configuring VRRP for IPv4 Router 2
R2(conf)#int te 2/31
R2(conf-if-te-2/31)#ip address 10.1.1.1/24
R2(conf-if-te-2/31)#vrrp-group 99
R2(conf-if-te-2/31-vrid-99)#priority 200
R2(conf-if-te-2/31-vrid-99)#virtual 10.1.1.3
R2(conf-if-te-2/31-vrid-99)#no shut
R2(conf-if-te-2/31)#show conf
!
interface TenGigabitEthernet 2/31
ip address 10.1.1.1/24
!
vrrp-group 99
priority 200
virtual-address 10.1.1.3
no shutdown
R2(conf-if-te-2/31)#end
R2#show vrrp
Virtual Router Redundancy Protocol (VRRP) 1030