Users Guide

LEVEL 2 DIAGNOSTIC
snakeOneGMac ................................................ PASS
snakeOneGPhy ................................................ PASS
snakeSfpPlusMac ............................................. PASS
snakeSfpPlusPhy ............................................. PASS
snakeStackMac ............................................... PASS
snakeStackPhy ............................................... PASS
--------- Group Test Statistics ---------
Cpu Name : C1048P
Total : 53
Passed : 49
Failed : 4
Aborted : 0
Elapsed time : 00H:09M:18S
Stop reason : after completion
------ Failed tests (level, times) ------
usbAccess (0, 1)
sfpPlusPhyExtLink (1, 1)
sfpPlusPhyExtSpeed (1, 1)
usbRW (1, 1)
The following example shows how to run offline diagnostics for PE in Debug mode.
NOTE: Dell Networking highly recommends reloading the system after running the offline diagnostics in Debug mode on
the switch.
Dell#diag pe 0 stack-unit 1 level0 verbose no-reboot
Warning - diagnostic execution will cause multiple link flaps on the peer side - advisable to
shut
directly connected ports
Warning - It is highly recommended to reboot the system after Offline Diagnostics
Proceed with Diags [confirm yes/no]: y
00:37:32: %C9010:0 %DIAGAGT-6-DA_DIAG_STARTED: Starting diags on stack unit 0
Dell#00:37:32 : Approximate time to complete the Diags ... 1 Min 30 Sec
Dell#
WARNING: Reboot is highly recommended after running Offline Diagnostics in Debug Mode. Debug
Mode can be
used only for troubleshooting specific test issue.
The following example shows the show diag information command issued from a PE console, after running the offline
diagnostics.
Dell#
Dell#show diag pe 0 stackunit 0 information -
Diag information:
Diag software image version:
9-0-0-23
-------------------------------------------------------------------
pe 0 stack-unit Member 0: Unit diags are done (Stackunit Offline).
.
-------------------------------------------------------------------
Running Offline Diagnostics on a Standalone Switch
To run offline diagnostics on a Standalone Switch:
1 Shut down the directly connected port extender ports before you run offline diagnostics.
2 Place the entire system or particular linecard in offline state.
Debugging and Diagnostics 291