Users Guide

Create a Rule for a Redirect-list
Use the following command in CONFIGURATION REDIRECT-LIST mode to set the rules for the redirect list. You can enter the
command multiple times and create a sequence of redirect rules. Use the seq nn redirect version of the command to organize
your rules.
Table 63. Create a Rule for a Redirect-list
Command Syntax Comman
d Mode
Purpose
{seq sequence-number}
redirect {ip-address|
tunnel tunnel-id}
[track obj-id]
{protocol-type}
{source mask | any |
host ip-address}
{destination mask |
any | host ip-address}
[bit] [operators]}
REDIRECT
-LIST
Configure a rule for the redirect list.
ip-address is the forwarding router’s address
tunnel — keyword to configure the tunnel settings.
tunnel-id is used to redirect the traffic.
Protocol-type — Enter one of the following keywords as the protocol type
• icmp for Internet Control Message Protocol
• ip for Any Internet Protocol
• tcp for Transmission Control Protocol
• udp for User Datagram Protocol
Optional
sequence-number (Optional) — Configures a rule with an assigned sequence
number for the redirect list. Enter a number from 1 to 65535.
track — keyword to enable tracking.
track <obj-id> is used to track the object-id for a host reachability track object.
Enter a number from 1 to 500. The track object should correspond to the host
tracking of the forwarding router’s IP address configured in this rule.
ip-protocol-number or protocol-type is the type of protocol to be redirected
FORMAT: 0-255 for IP protocol number, or enter protocol type (Optional):
• icmp — Internet Control Message Protocol
• ip — Any Internet Protocol
• tcp — Transmission Control Protocol
• udp — User Datagram Protocol
bit — (Optional) For TCP protocol type only, enter one or a combination of the
following TCP flags:
• ack = acknowledgement
• fin = finish (no more data from the user)
• psh = push function
• rst = reset the connection
• yn = synchronize sequence numbers
• urg = urgent field
operators — For TCP and UDP parameters only. Enter one of the following logical
operand:
• eq = equal to
• neq = not equal to
• gt = greater than
Policy-based Routing (PBR) 676