Users Guide

Last failover timestamp: None
Last failover Reason: None
Last failover type: None
-- Last Data Block Sync Record: --
------------------------------------------------
stack-unit Config: succeeded Jun 30 2015 15:26:47
Runtime Event Log: succeeded Jun 30 2015 15:26:47
Running Config: succeeded Jun 30 2015 15:26:47
Removing a Unit from a PE Stack
In a PE stack, the parent C9010 synchronizes the software configuration on all stack units. A stack member that is disconnected
from the stack maintains this configuration.
To remove a stack member from the stack, disconnect the stacking cables from the unit. You may disconnect the cable at any
time, whether the unit is powered or unpowered, online or offline.
Examples of Removing a PE Stack Member
The following example shows the status of stack-unit 1 before it is removed from the PE stack.
Dell#show pe 0 system brief
Stack MAC : 00:01:e8:8a:df:e6
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version Ports
-----------------------------------------------------------
0 Management online C1048P C1048P 1-0(0-4149) 52
1 Member online C1048P C1048P 1-0(0-4149) 52
2 Member not present
3 Standby online C1048P C1048P 1-0(0-4149) 52
4 Member not present
5 Member not present
6 Member not present
7 Member not present
The following example displays the status of stack-unit 1 after it is removed from the PE stack.
Dell#show pe 0system brief
Stack MAC : 00:01:e8:8a:df:e6
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version Ports
-------------------------------------------------------
0 Management online C1048P C1048P 1-0(0-4149) 52
1
Member not present
2 Member not present
3 Standby online C1048P C1048P 1-0(0-4149) 52
4 Member not present
5 Member not present
6 Member not present
7 Member not present
Verifying a PE Stack Master and Standby
The Status LED on the front panel of a PE stack unit identifies the unit’s role in the stack.
• Off indicates that the unit is a stack member.
• Off also indicates that the unit is stack standby.
• Solid green indicates that the unit is the stack master (management unit).
Port Extender (PE) Stacking 712