Users Guide

Displaying Show sFlow on a Line Card
To view sFlow statistics on a specified line card, use the following command.
• Display sFlow configuration information and statistics on the specified interface.
EXEC mode
show sflow linecard slot-number
Example of Viewing sFlow Configuration (Line Card)
Dell#show sflow linecard 1
Linecard 1
Samples rcvd from h/w :165
Samples dropped for sub-sampling :69
Total UDP packets exported :77
UDP packets exported via RP :77
UDP packets dropped :
Configuring Specify Collectors
The sflow collector command allows identification of sFlow collectors to which sFlow datagrams are forwarded.
You can specify up to two sFlow collectors. If you specify two collectors, the samples are sent to both.
• Identify sFlow collectors to which sFlow datagrams are forwarded.
CONFIGURATION mode
sflow collector ip-address agent-addr ip-address [number [max-datagram-size number] ] | [max-
datagram-size number ]
The default UDP port is 6343.
The default max-datagram-size is 1400.
Changing the Polling Intervals
The sflow polling-interval command configures the polling interval for an interface in the maximum number of seconds
between successive samples of counters sent to the collector.
This command changes the global default counter polling (20 seconds) interval. You can configure an interface to use a
different polling interval.
To configure the polling intervals globally (in CONFIGURATION mode) or by interface (in INTERFACE mode), use the following
command.
• Change the global default counter polling interval.
CONFIGURATION mode or INTERFACE mode
sflow polling-interval interval value
– interval value: in seconds.
The range is from 15 to 86400 seconds.
The default is 20 seconds.
sFlow 872