Users Guide

filename copyDestFileType.index i 3 copyServerAddress.index a server-ip-address
copyUserName.index s server-login-id copyUserPassword.index s server-login-password
Example of Copying a Binary File From the Server to the Startup-Configuration via FTP
> snmpset -v 2c -c private -m ./f10-copy-config.mib 10.10.10.10 copySrcFileType.10 i 1
copySrcFileLocation.10 i 4 copyDestFileType.10 i 3 copySrcFileName.10 s /home/myfilename
copyServerAddress.10 a 172.16.1.56 copyUserName.10 s mylogin copyUserPassword.10 s mypass
Additional MIB Objects to View Copy Statistics
Dell Networking provides more MIB objects to view copy statistics, as shown in the following table.
Table 85. Additional MIB Objects for Copying Configuration Files via SNMP
MIB Object OID Values Description
copyState .1.3.6.1.4.1.6027.3.5.1.1.1.1.11
1= running
2 = successful
3 = failed
Specifies the state of the copy
operation.
copyTimeStarted .1.3.6.1.4.1.6027.3.5.1.1.1.1.12 Time value Specifies the point in the up-
time clock that the copy
operation started.
copyTimeCompleted .1.3.6.1.4.1.6027.3.5.1.1.1.1.13 Time value Specifies the point in the up-
time clock that the copy
operation completed.
copyFailCause .1.3.6.1.4.1.6027.3.5.1.1.1.1.14
1 = bad filename
2 = copy in progress
3 = disk full
4 = file exists
5 = file not found
6 = timeout
7 = unknown
Specifies the reason the copy
request failed.
copyEntryRowStatus .1.3.6.1.4.1.6027.3.5.1.1.1.1.15 Row status Specifies the state of the copy
operation. Uses CreateAndGo
when you are performing the
copy. The state is set to active
when the copy is completed.
Obtaining a Value for MIB Objects
To obtain a value for any of the MIB objects, use the following command.
• Get a copy-config MIB object value.
snmpset -v 2c -c public -m ./f10-copy-config.mib force10system-ip-address [OID.index | mib-
object.index]
index: the index value used in the snmpset command used to complete the copy operation.
Simple Network Management Protocol (SNMP) 891