Administrator Guide

DellEMC(conf)#pe-lldp-multiplier 5
DellEMC(conf)#
DellEMC(conf)#do show running-config | grep pe-
pe-lldp-multiplier 5
DellEMC(conf)#
Example
(unconfigure the
PE LLDP
multiplier)
DellEMC(conf)#no pe-lldp-multiplier
DellEMC(conf)#
DellEMC(conf)#do show running-config | grep pe-
DellEMC(conf)#
protocol lldp (Configuration)
Enable the LLDP globally on the switch.
C9000 Series
Syntax
protocol lldp
To disable LLDP globally on the chassis, use the no protocol lldp command.
Defaults Enabled.
Command Modes
CONFIGURATION(conf-lldp)
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
protocol lldp (Interface)
Enter the LLDP protocol in INTERFACE mode.
C9000 Series
Syntax
[no] protocol lldp
To return to the global LLDP configuration mode, use the no protocol lldp command from Interface mode.
Defaults LLDP is not enabled on the interface.
Command Modes INTERFACE (conf-if-interface-lldp)
1016 Link Layer Discovery Protocol (LLDP)