Administrator Guide

Port extender (PE) processes and advertises LLDP power-via-MDI TLVs when the LLDP advertisement of the
TLV is enabled on the PE in class power management mode. Incoming LLDP messages are processed only when
the PE is in class power management mode.
Related
Commands
debug lldp interface — debugs LLDP.
show lldp neighbors — displays the LLDP neighbors.
show running-config lldp — displays the LLDP running configuration.
advertise med softphone-voice
To advertise softphone to enable IP telephony on a computer so that the computer can be used as a phone, configure the system.
C9000 Series
Syntax
advertise med softphone-voice {vlan-id layer2_priority DSCP_value} | {priority-
tagged number}
To return to the default, use the no advertise med softphone-voice {vlan-id
layer2_priority DSCP_value} | {priority-tagged number} command.
Parameters
vlan-id Enter the VLAN ID. The range is from 1 to 4094.
layer2_priority Enter the Layer 2 priority (C-Series and E-Series only). The range is from 0 to 7.
DSCP_value Enter the DSCP value (C-Series and E-Series only). The range is from 0 to 63.
priority-tagged
number
Enter the keywords priority-tagged then the Layer 2 priority. The range is from 0 to
7.
Defaults unconfigured.
Command Modes CONFIGURATION (conf-lldp)
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series and E-Series.
Related
Commands
debug lldp interface — debugs LLDP.
show lldp neighbors — displays the LLDP neighbors.
show running-config lldp — displays the LLDP running configuration.
1026 Link Layer Discovery Protocol (LLDP)