Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

1031

Version Description

9.9(0.0) Introduced on the C9010.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.1 Introduced on the S4810.

E-Series legacy

command

Usage Information

After you enable multicast, you can enable IGMP and PIM on an interface. In INTERFACE mode, enter the ip

pim sparse-mode command to enable IGMP and PIM on the interface.

Commands

ip pim sparse-mode — enables IGMP and PIM on an interface.

show ip multicast-cam

Display the content addressable memory (CAM) size and the portions allocated for IP multicast traffic.

Syntax

show ip multicast-cam linecard slot-id port-set port-pipe

Parameters

linecard

slot-id

Enter the keyword linecard with a slot number to select the line card for which to

gather information. The range of Z9500 slot IDs is from 0 to 2.

port-set

port-pipe

Enter the keyword port-set with a port-pipe number to select the port pipe for which

to gather information. The range of port pipes is from 0 to 3.

Command Modes

• EXEC

• EXEC Privilege

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.