Administrator Guide
Object Tracking
Object Tracking supports IPv4 and IPv6 protocols.
Object tracking allows you to define objects of interest, monitor their state, and report to a client when a change in an object’s state
occurs. The following tracked objects are supported:
• Link status of Layer 2 interfaces
• Routing status of Layer 3 interfaces (IPv4 and IPv6)
• Reachability of IPv4 and IPv6 routes
• Metric thresholds of IPv4 and IPv6 routes
You can configure client applications, such virtual router redundancy protocol (VRRP), to receive a notification when the state of a
tracked object changes.
This chapter contains the following sections:
• IPv4 Object Tracking Commands
• IPv6 Object Tracking Commands
Topics:
• IPv4 Object Tracking Commands
• IPv6 Object Tracking Commands
IPv4 Object Tracking Commands
The following section describes the IPv4 object tracking commands.
debug track
Enable debugging for tracked objects.
C9000 Series
Syntax
debug track [all | notifications | object-id]
Parameters
all Enables debugging on the state and notifications of all tracked objects.
notifications Enables debugging on the notifications of all tracked objects.
object-id
Enables debugging on the state and notifications of the specified tracked object. The
range is from 1 to 500.
Defaults Enable debugging on the state and notifications of all tracked objects (debug track all).
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
38
1090 Object Tracking