Administrator Guide
Configure the UP and DOWN thresholds for each tracked route with the threshold metric command. The
default UP threshold is 254; the default DOWN threshold is 255. The notification of a change in the state of a
tracked object is sent when a metric value crosses a configured threshold.
The tracking process uses a protocol-specific resolution value to convert the actual metric in the routing table to a
scaled metric in the range 0 to 255. You can configure the resolution value used to scale route metrics for
supported protocols with the track resolution ip route and track resolution ipv6 route
commands.
Related
Commands
• track ip route metric threshold – configures object tracking on the threshold of an IPv4 route metric.
• track resolution ip route – configures the protocol-specific resolution value used to scale an IPv4 route metric.
track interface ip routing
Configure object tracking on the routing status of an IPv4 Layer 3 interface.
C9000 Series
Syntax
track object-id interface interface ip routing
To return to the default setting, use the no track object-id command.
Parameters
object-id
Enter the ID number of the tracked object. The range is from 1 to 500.
interface
Enter one of the following values:
• For a 1-Gigabit Ethernet interface, enter gigabitethernet and the slot-number/
port-number.
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a port channel interface, enter the keywords port-channel then a number.
• For a 10-Gigabit Ethernet interface, enter tengigabitethernet and the slot-
number/ port-number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced.
Usage Information Use this command to create an object that tracks the routing state of an IPv4 Layer 3 interface:
• The status of the IPv4 interface is UP only if the Layer 3 status of the interface is UP and the interface has a
valid IP address.
• The Layer 3 status of an IPv4 interface goes DOWN when its Layer 3 status goes down (for a Layer 3 VLAN,
all VLAN ports must be down) or the IP address is removed from the routing table.
Related
Commands
• show track – displays information about tracked objects, including configuration, current state, and clients
which track the object.
• track interface line-protocol – configures object tracking on the line-protocol state of a Layer 2 interface.
1096 Object Tracking