Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

1101

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.2(1.0) Introduced on the Z9500.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Added support for the Multi-Process OSPF.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

6.1.1.1 Introduced on the E-Series.

Usage Information In the Dell Networking operating software, cost is defined as reference bandwidth/bandwidth.

Commands

area stub — creates a stub area.

area nssa

Specify an area as a not so stubby area (NSSA).

C9000 Series

Syntax

area area-id nssa [default-information-originate] [no-redistribution] [no-

summary]

To delete an NSSA, use the no area area-id nssa command.

Parameters

area-id

Specify the OSPF area in dotted decimal format (A.B.C.D.) or enter a number from zero

(0) to 65535.

no-redistribution (OPTIONAL) Specify that the redistribute command does not distribute routes into

the NSSA. Only use this command in an NSSA area border router (ABR).

default-

information-

originate

(OPTIONAL) Allows external routing information to be imported into the NSSA by using

Type 7 default.

no-summary (OPTIONAL) Specify that no summary LSAs should be sent into the NSSA.

Defaults Not configured.

Command Modes ROUTER OSPF