Administrator Guide

discard
Use the discard command to cancel the uncommitted changes made to common configurations in the Configuration Terminal Batch
mode.
C9000 Series
Syntax
discard
Default None
Command Modes CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced on the C9010.
Usage Information The Configuration Terminal Batch mode is used to setup common configurations on a port extender connected in
a dual-homing environment. Use the discard command to cancel the uncommitted common configuration
changes.
Example The following example shows the configurations being discarded:
Dell(conf-b)#interface vlan 2000
Dell(conf-b-if-vl-2000)#tagged peGigE 184/0/1
Dell(conf-b-if-vl-2000)#show config
interface vlan 2000
tagged peGigE 184/0/1
Dell(conf-b-if-vl-2000)#discard
Dell(conf-b)#show config
Dell(conf-b)#exit
Dell#
import peer-config
Use import peer-config to import the common configurations from the peer chassis.
C9000 Series
Syntax
import peer-config
Default None
Command Modes
EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced on the C9010.
Usage Information Use the import peer-config to import the common configurations from the peer chassis and apply them in
the local system.
1308 Port Extenders (PE)