Administrator Guide

stack-unit unit
number
Enter the keyword stack-unit and the unit number. Range is from 0 to 7.
Defaults None
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Usage Information
The upgrade poe-controller pe command is used to manually upgrade the PoE controller firmware for a
specified port extender unit.
You can upgrade the PoE controller firmware using the firmware image that is packed with the Dell Networking
OS. Once the upgrade is successful, the Port Extender reloads automatically.
In a dual homing setup, you can use this command only from the primary VLT peer.
Example
Dell#upgrade poe-controller pe 254 stack-unit 1
show power inline
Display the PoE power allocation on a specified port extender.
C9000 Series
Syntax
show power inline {pe pe-id stack-unit unit number | interface interface }
Parameters
pe pe-id Enter the keyword pe and the port extender ID. Range is from 0 to 255.
stack-unit unit
number
Enter the keyword stack-unit and the stack unit number Range is from 0 to 7.
interface interface
Enter the interface keyword, and specify one of the following interface types:
• For a PE Gigabit Ethernet interface, enter the keyword peGigE. You must specify a
pe-id/Unit/Port for the interface.
• For a port extender 10-Gigabit Ethernet interface, enter the keyword peTenGigE
then the pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255;
the stack-unit unit-number range is from 0 to 7; and the port-id range is 25 to 28 or
49 to 52 depending on the PE.
Defaults None
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.13.0.1P1 Introduced peTenGigE interface support on the C9010.
9.9(0.0) Introduced on the C9010.
Usage Information
The following describes the output fields of the show power inline command:
1330 Port Extenders (PE)