Administrator Guide

Version Description
8.3.7.0 Introduced on the S4810.
6.1.1.1 Introduced on the E-Series
Usage Information
Use the default pre-defined profiles or configure your own profile. You cannot delete the pre-defined profiles or
their default values. This command enables WRED configuration mode —(conf-wred).
Use this command in Configuration Terminal Batch mode to create the WRED profile in a dual-homing setup.
Related
Commands
threshold — specifies the minimum and maximum threshold values of the WRED profile.
show hardware
This command displays hardware buffer configurations and counters.
C9000 Series
Syntax
show hardware {linecard number | pe-unit number stack-unit number} buffer unit
number port number buffer-info
Parameters
linecard Line card 0 – 11.
pe-unit PE-unit is use to specify the PE. PE ID 1 – 255.
stack-unit Stack-unit is used to specify the statck unite in the stacked PE system. Stack-unit within
a PE ID 0 – 7.
buffer-unit Buffer unit is used to specify the port-pipe. Buffer-unit 0 – 0.
Defaults None
Command Modes Exec
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
1392 Quality of Service (QoS)