Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

1431

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.2(1.0) Introduced on the Z9500.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.5.1.0 Added support for 4-port 40G line cards on ExaScale.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Introduced on the S-Series.

7.6.1.0 Introduced on the C-Series.

6.2.1.1 Introduced on the E-Series.

Usage Information Although the passive interface does not send or receive routing updates, the network on that interface still

includes in RIP updates sent using other interfaces.

Commands

neighbor — enables RIP for a specified network.

network — defines a neighbor.

redistribute

Redistribute information from other routing instances.

C9000 Series

Syntax

redistribute {connected | static}

To disable redistribution, use the no redistribute {connected | static} command.

Parameters

connected Enter the keyword connected to specify that information from active routes on

interfaces is redistributed.

static Enter the keyword static to specify that information from static routes is redistributed.

Defaults Not configured.

Command Modes ROUTER RIP