Administrator Guide

redistribute ospf
Redistribute routing information from an OSPF process.
C9000 Series
Syntax
redistribute ospf process-id [match external {1 | 2} | match internal | metric
metric-value] [route-map map-name]
To disable redistribution, use the no redistribute ospf process-id [match external {1 | 2}
| match internal | metric metric-value] [route-map map-name] command.
Parameters
process-id Enter a number that corresponds to the OSPF process ID to redistribute. The range is
from 1 to 65355.
match external {1 |
2}
(OPTIONAL) Enter the keywords match external then the numbers 1 or 2 to
indicated that external 1 routes or external 2 routes should be redistributed.
match internal (OPTIONAL) Enter the keywords match internal to indicate that internal routes
should be redistributed.
metric metric-
value
(OPTIONAL) Enter the keyword metric then a number as the metric value. The range is
from 0 to 16.
route-map map-
name
(OPTIONAL) Enter the keywords route-map then the name of a configured route map.
Defaults Not configured.
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
router rip
To configure and enable RIP, enter ROUTER RIP mode.
C9000 Series
Syntax
router rip
To disable RIP, use the no router rip command.
Defaults Disabled.
Command Modes CONFIGURATION
1436 Routing Information Protocol (RIP)