Administrator Guide

Version Description
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on S-Series Stacking.
8.1.1.0 Introduced on the E-Series ExaScale.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage Information
Dell Networking OS enhances the sflow implementation for real time traffic analysis on the E-Series to provide
extended gateway information in cases where the destination IP addresses are learned by different routing
protocols and for cases where the destination is reachable over ECMP.
Use this command in Configuration Terminal Batch mode to enable the packing information in a dual-homing
setup.
Related
Commands
show sflow — displays the sFlow configuration.
sflow max-header-size extended
Set the maximum header size of a packet to 256 bytes.
C9000 Series
Syntax
sflow max-header-size extended
To reset the maximum header size of a packet, use the[no] sflow max-header-size extended
command.
Parameters
extended Enter the keyword extended to copy 256 bytes from the sample packets to sFlow
datagram.
Defaults 128 bytes
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.8(0.0P5) Introduced on the S4048-ON.
1538 sFlow