Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

1601

Version Description

9.9(0.0) Introduced on the C9010.

9.2(1.0) Introduced on the Z9500.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.7.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

6.2.1.1 Introduced on the E-Series.

Usage Information STP is not enabled when you enter SPANNING TREE mode. To enable STP globally on the switch, use the no

disable command from SPANNING TREE mode.

Example

Dell(conf)#protocol spanning-tree 0

Dell(config-stp)#

Commands

disable — disables spanning tree group 0. To enable spanning tree group 0, use the no disable command.

show config

Display the current configuration for the mode. Only non-default values display.

C9000 Series

Syntax

show config

Command Modes SPANNING TREE

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.