Administrator Guide

show vlt mismatch
Display mismatches in VLT parameters.
C9000 Series
Syntax
show vlt mismatch
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
Version
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced the support for Q-in-Q implementation over VLT on the S-Series and Z-Series.
9.5(0.1) Introduced on the Z9500.
9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
9.0.2.0 Introduced on the S6000.
Example
Dell#show vlt mismatch
Domain
-------
Parameters Local Peer
---------- ----- -----
Unit-ID 0 1
Vlan-config
------------
Vlan-ID Local Mode Peer Mode
------- ---------- ---------
100 -- L3
Vlan IPV4 Multicast Status
--------------------------
Vlan-ID Local Status Peer Status
-------- ------------ -----------
4094 Active Inactive
Dell#
Example for Q-in-
Q implementation
over VLT
Dell#show vlt mismatch
Domain
------
Parameters Local Peer
---------- ----- ----
PB for stp Enabled Disabled
Vlan-type-config
----------------
Codes:: P - Primary, C - Community, I - Isolated, N - Normal vlan, M - Vlan-
1678 Virtual Link Trunking (VLT)