Administrator Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
priority
Specify a VRRP priority value for the VRRP group. The VRRP protocol uses this value during the MASTER election process.
C9000 Series
Syntax
priority priority
To return to the default value, use the no priority command.
Parameters
priority Enter a number as the priority. Enter 255 only if the router’s virtual address is the same as
the interface’s primary IP address (that is, the router is the OWNER). The range is from 1
to 255. The default is 100.
Defaults 100
Command Modes VRRP
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.16.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information
To guarantee that a VRRP group becomes MASTER, configure the VRRP group’s virtual address with same IP
address as the interface’s primary IP address and change the priority of the VRRP group to 255.
If you set the priority command to 255 and the virtual-address is not equal to the interface’s primary IP
address, an error message appears.
show config
View the non-default VRRP configuration.
C9000 Series
Syntax
show config [verbose]
1696 Virtual Router Redundancy Protocol (VRRP)