Administrator Guide

ip access-group
Assign an IP access list (IP ACL) to an interface.
Syntax
ip access-group access-list-name {in | out} [implicit-permit] [vlan vlan-id]
[vrf vrf-name]
To delete an IP access-group configuration, use the no ip access-group access-list-name {in |
out} [implicit-permit] [vlan vlan-id][layer3] command.
Parameters
access-list-name Enter the name of a configured access list, up to 140 characters.
in Enter the keyword in to apply the ACL to incoming traffic.
out Enter the keyword out to apply the ACL to outgoing traffic.
implicit-permit (OPTIONAL) Enter the keyword implicit-permit to change the default action of the
ACL from implicit-deny to implicit-permit (that is, if the traffic does not match the filters
in the ACL, the traffic is permitted instead of dropped).
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the ID numbers of the VLANs. The range is
from 1 to 4094 (you can use IDs from 1 to 4094).
vrf vrf-name (OPTIONAL) Enter the keyword vrf then the ID numbers of the VRFs. The range is from
1 to 63 (you can use IDs from 1 to 63).
NOTE: When you specify a single VRF, use the name of the VRF instead of
the VRF ID number. Use the VRF ID numbers only when you specify a range
of VRFs.
layer3 (OPTIONAL) Enter the keyword layer3 to enable layer 3 mode. It ensures that all the
ACL rules in the access-group are applied only for L3 router packets.
Defaults Not enabled.
Command Modes INTERFACE/VRF MODE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names were up
to 16 characters long.
216 Access Control Lists (ACL)