Administrator Guide

Usage Information The VLAN ContentAware Processor (VCAP) application is a pre-ingress CAP that modifies the VLAN settings
before packets are forwarded. To support the ACL CAM optimization functionality, the CAM carving feature is
enhanced. A total of four VACP groups are present, of which two are for fixed groups and the other two are for
dynamic groups. Out of the total of two dynamic groups, you can allocate zero, one, or two flow processor (FP)
blocks to iSCSI counters, Open Flow and ACL VLAN optimization. You can configure CAM FP blocks for only two
of these ACL VLAN services at a time. Use this command in Configuration Terminal Batch mode to configure in a
dual-homing setup.
description (ACL VLAN Group)
Add a text description of an ACL VLAN group.
C9000 Series
Syntax
description text
Parameters
description Enter a text to identify the ACL VLAN group (80 characters maximum).
Default No default behavior or values
Command Modes ACL-VLAN-GROUP CONFIGURATION (conf-acl-vl-grp)
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.0) Introduced on the Z9500.
9.3(0.0) Introduced on the S4810, S4820T, and Z9000.
Usage Information Enter a description for each ACL VLAN group that you create for effective administrative and logging purposes.
member vlan (ACL VLAN Group)
Add VLAN members to an ACL VLAN group.
C9000 Series
Syntax
member vlan {VLAN-range}
Parameters
VLAN-range
Enter the member VLANs using comma-separated VLAN IDs, a range of VLAN IDs, a
single VLAN ID, or a combination. For example:
Comma-separated: 3, 4, 6
Range: 5-10
Combination: 3, 4, 5-10, 8
Default None
Command Modes ACL-VLAN-GROUP CONFIGURATION (conf-acl-vl-grp)
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.0) Introduced on the Z9500.
9.3(0.0) Introduced on the S4810, S4820T, and Z9000.
Usage Information At a maximum, there can be only 32 VLAN members in all ACL VLAN groups. A VLAN can belong to only one ACL
VLAN group at a time.
250 Access Control Lists (ACL)