Administrator Guide

Version Description
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.2.1.0 Introduced.
Usage Information
When you enable soft-reconfiguration for a neighbor and you execute the clear ip bgp soft in command,
the update database stored in the router is replayed and updates are re-evaluated. With this command, the replay
and update process is triggered only if route-refresh request is not negotiated with the peer. If the request is
indeed negotiated (after executing the clear ip bgp soft in command), BGP sends a route-refresh
request to the neighbor and receives all of the peer’s updates.
Related
Commands
clear ip bgp — activates inbound policies without resetting the BGP TCP session.
capture bgp-pdu max-buffer-size
Set the size of the BGP packet capture buffer. This buffer size pertains to both IPv4 and IPv6 addresses.
C9000 Series
Syntax
capture bgp-pdu max-buffer-size 100-102400000
Parameters
100-102400000 Enter a size for the capture buffer.
Defaults 40960000 bytes
Command Modes
• EXEC
• EXEC Privilege
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced
Related
Commands
• show capture bgp-pdu neighbor – configures a route reflector and clients.
• capture bgp-pdu neighbor – enables capture of an IPv4 BGP neighbor packet.
capture bgp-pdu neighbor (ipv6)
Enable capture of an IPv6 BGP neighbor packet.
C9000 Series
Syntax
capture bgp-pdu neighbor ipv6-address direction {both | rx | tx}
To disable capture of the IPv6 BGP neighbor packet, use the no capture bgp-pdu neighbor ipv6-
address command.
Parameters
ipv6-address Enter the IPv6 address of the target BGP neighbor.
direction {both |
rx | tx}
Enter the keyword direction and a direction— either rx for inbound, tx for
outbound, or both.
Defaults Not configured.
434 Border Gateway Protocol