Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

611

612

613

614

615

616

617

618

619

620

Version Description

9.13(0.0) Enhanced the command to map multiple IP addresses to one MAC address. Enhanced to

support DHCP snooping in a VLT setup.

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100-ON.

9.8(2.0) Introduced on the S3100 series.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.5.1.0 Added support for 4-port 40G line cards on the E-Series.

8.3.7.0 Introduced on the S4810.

8.3.1.0 Introduced on the E-Series.

7.8.1.0 Introduced on the C-Series and S-Series.

Usage Instructions

You can map multiple IP addresses to the same MAC address.

Commands

• show ip dhcp snooping — display the contents of the DHCP binding table.

ip dhcp snooping database

Delay writing the binding table for a specified time.

C9000 Series

Syntax

ip dhcp snooping database write-delay minutes

Parameters

minutes

The range is from 5 to 21600.

Defaults none

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.