Administrator Guide

Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series.
7.5.1.0 Introduced.
Usage Information Executing this command without the optional ring-id command clears the statistics counters on all the
available rings. The system requires a command line confirmation before the command executes. This command
clears the following counters:
• hello Rx and Tx counters
• Topology change Rx and Tx counters
• The number of state change counters
Example
Dell# clear frrp
Clear frrp statistics counter on all ring [confirm] yes
Dell#clear frrp 4
Clear frrp statistics counter for ring 4 [confirm] yes
Dell#
Related
Commands
show frrp — displays the Resilient Ring Protocol configuration.
debug frrp
Clear the FRRP statistics counters.
C9000 Series
Syntax
debug frrp {event | packet | detail} [ring-id] [count number]
To disable debugging, use the no debug frrp {event | packet | detail} {ring-id}
[countnumber] command.
Parameters
event Enter the keyword event to display debug information related to ring protocol
transitions.
packet Enter the keyword packet to display brief debug information related to control packets.
detail Enter the keyword detail to display detailed debug information related to the entire ring
protocol packets.
ring-id (Optional) Enter the ring identification number. The range is from 1 to 255.
count number Enter the keyword count then the number of debug outputs. The range is from 1 to
65534.
Defaults Disabled.
Command Modes CONFIGURATION (conf-frrp)
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
652 Force10 OS Resilient Ring Protocol (FRRP)